In certain cases the SmartSense Multi Sensors are
missing the Y and Z axis, causing an exception
during .parseAxis(). This change checks that all
3 axis are present before processing the rest of
the message.
This works around the fact that sengled element touches can get back
into a state of reporting an invalid value (of FF) if the physical
button on the bulb is used to cycle back to the 100% state. Here we
interpret FF as FE for sengled and then issue a move to level command to
put it in a state where it will report FE until the level is changed
again.
This resolves: https://smartthings.atlassian.net/browse/DVCSMP-2597
This works around the sengled bulbs not following the ZCL spec and using
the value 0xFF as a valid level (the spec says it should be invalid).
It does this by manually setting the level of the bulb to
0xFE (SmartThings 100%) when it is configured, or if it previously had a
level set, manually setting it to that value. This avoids the issue of
the bulb reporting 0xFF and having the library ignore it because it is
an invalid value.
This resolves: https://smartthings.atlassian.net/browse/ICP-691
In configure we were setting up the battery level to be reported every
20 seconds but we weren't reading the attribute so it would take 20
seconds before the battery level was reported. Now we read it during
configure so it is updated right away after join.
https://smartthings.atlassian.net/browse/DVCSMP-2568
In configure we were setting up the battery level to be reported every
20 seconds but we weren't reading the attribute so it would take 20
seconds before the battery level was reported. Now we read it during
configure so it is updated right away after join.
https://smartthings.atlassian.net/browse/DVCSMP-2568
Motion Sensor
- Passive Infrared Sensor (PIR)
- 12’ range - 90 coverage
- Programmable timeout
- Control four associated devices
Temperature Sensor
- -10 - 80C range
- 0.1C resolution
Light Level Sensor
- Relative light level 0-100%
Color Indicator Night Light
- Eight colors
Wall Powered
- 110VAC 60Hz
- No wires - just plug it in
- Never needs batteries
Wireless Z-Wave ® RF Technology
- Fifth generation chipset
- Z-Wave range extender
- 100,000 bits/sec data rate
- 300’ RF range
- Over-the-air firmware update
- Push button to join network
- Z-Wave Plus certified
Designed and assembled in USA
