To use this device type in SmartApps, use "capability.doorControl" in Preferences to select the controller.
Then you can reference the state of the device with device.currentValue("motor") or device.currentMotor.
The device can be in one of three states: up, down, stop, e.g. if(device.currentMotor == "up") {...}
There are three commands available: up(), down(), stop(), e.g. device.up()
After you include the Aeon device into ST, edit its device type in the IDE to be "Aeon Motor Controller"
Down turns on motor M1, and Up turns on motor M2.
ZigBee locks report battery percentage remaining in .5% increments. However
the Low Battery Handler Smart App in Hello Home expects it to be an integer.
https://smartthings.atlassian.net/browse/DVCSMP-1189
Detect and mark device offline within 5 minutes.
Show Device offline in device tile.
Show Device offline in Recent Activity.
Log the current IP address to Recent Activity.
Log the changed IP address to Recent Activity.
Support 'Turning on' and 'Turning off' (blindly changing the state of
device to ON or OFF without confirming bulb responded correctly)
Turn on / off through Wemo-App reflected timely in SmartThings
App/Ecosystem.
Manual turn on / off of device is reflected timely in SmartThings
App/Ecosystem.
Lower case createEvent
Bug Fixes
Bug fixes
setOffline
Minor cosmetic fixes
if you use the hue native app to adjust the dimmer setting, smartthings will reset the dimmer to previous value when toggling from ST app (and automations)
- Show batteryStatus tile insteady of battery tile to be able to display both when sensor is USB powered or battery powered
- Remove background for illuminance. This can be added when we have best practice of showing colors for lux.
- Instead of using powerSupply:failed, configurationGet cmd is sent and then the configure() is triggered by configurationReport to determine powerSupply (USB Cable/Battery)
- Instead of querying battery level on wake up, battery report is put in association group 2 that is configured to report every 6 hours by default
- Update configure() to send both unsecure and secure configuration commands when sensor is joined normally or securely
The following changes has been made to the original Aeon Multisensor device type handler to improve and modernize it:
1. Add "powerSupply" attribute to be able to tell power source (USB Cable/Battery)
2. Add preference page for user to customize "motion delay time", "motion sensitivity", and "sensor report interval"
3. Add color backgroud of "illuminance" value tile
4. Add tile for "ultravioletIndex"
5. Add tile for "powerSupply"
6. Modify updated() to be able to send configuration commands to sensor whether it is powered by USB cable or battery
7. When battery operated, send command to get update battery level if it hasn't been reported for a while
8. Report MSR of the sensor
9. Add handle for ConfigurationReport command class to update the "powerSupply" tile and change opetion mode of the sensor accordingly
10. Update configure() to configure parameters changed by user in preference page
11. Take out the "Configure" tile and instead send the configuration commands on every wakeup (sensor is battey powered)
