* rgb(w) bulbs: fix hue/saturation conversion
The attributes used to report Hue and Saturation can have a value of
0-254. We want to translate this to a percentage of 0-100%. The HA
DTHs were dividing by 255 instead of the correct value of 254. Because
the wrong divisor was used the result would be off by a percent about
25% of the time. The ZLL DTHs had the same bug plus they were also
multipling the Hue by 360 instead of 100.
* rgb(w) bulbs: set hue & saturation in a single command
Previous two commands were being used to set Hue and Saturation. Now
a single command is used and a transition time of 0 so the color changes
must faster.
* Don't rely on reporting for hue, saturation and color temperature
Previously we were configuring the RGB(W) and Color Temperature bulbs
to report any Hue, Saturation and Color Temperature changes. Now we
manually read these attributes any time a command is executed that
changes them.
This works around the sengled bulbs not following the ZCL spec and using
the value 0xFF as a valid level (the spec says it should be invalid).
It does this by manually setting the level of the bulb to
0xFE (SmartThings 100%) when it is configured, or if it previously had a
level set, manually setting it to that value. This avoids the issue of
the bulb reporting 0xFF and having the library ignore it because it is
an invalid value.
This resolves: https://smartthings.atlassian.net/browse/ICP-691
In configure we were setting up the battery level to be reported every
20 seconds but we weren't reading the attribute so it would take 20
seconds before the battery level was reported. Now we read it during
configure so it is updated right away after join.
https://smartthings.atlassian.net/browse/DVCSMP-2568
In configure we were setting up the battery level to be reported every
20 seconds but we weren't reading the attribute so it would take 20
seconds before the battery level was reported. Now we read it during
configure so it is updated right away after join.
https://smartthings.atlassian.net/browse/DVCSMP-2568
Motion Sensor
- Passive Infrared Sensor (PIR)
- 12’ range - 90 coverage
- Programmable timeout
- Control four associated devices
Temperature Sensor
- -10 - 80C range
- 0.1C resolution
Light Level Sensor
- Relative light level 0-100%
Color Indicator Night Light
- Eight colors
Wall Powered
- 110VAC 60Hz
- No wires - just plug it in
- Never needs batteries
Wireless Z-Wave ® RF Technology
- Fifth generation chipset
- Z-Wave range extender
- 100,000 bits/sec data rate
- 300’ RF range
- Over-the-air firmware update
- Push button to join network
- Z-Wave Plus certified
Designed and assembled in USA
